|
Product Details:
Payment & Shipping Terms:
|
| Container Capacity: | 200Ml-1000ML | Applicable Material: | HDPE LDPE PP PETG PVC PC PA EVOH |
|---|---|---|---|
| Product: | Pesticide Bottle | Multi-laye: | 4 Layer |
| Mahine Type: | Toggle Type | Feature: | High Barrier Botte |
| High Light: | High Barrier Pesticide Bottle Molding Machine,4 Layers Blow Moulding Machine,HDPE Automatic Blow Moulding Machine |
||
4 Layers Blow Moulding Machine For High Barrier Pesticide Bottle
Introduction:
MP90FS IML is specifically designed for making bottles from 600ml up to maximum 10L. It is hydraulic driven with accrate eletrical control system. MP90FS IML has single stations to increase the production efficiency. Also, it has variety of choice of die heads. With more than 10 years of success in the market, MP70FS IML is updated to be one of the most reliable and popular model in the world.
Adjusting of blow pin
Do adjust blow pin before normal operation begins, or pen will be damaged. So after change of placing rack oil cylinder or mould installation position, blow pin must be adjusted again. It is required that blowing mouth should insert mould bottle mouth, central lines of blowing mouth and mould bottle mouth should match and conform, and force of blow pin should be proper. Adjusting methods are as follow:
1) Start machine manually. Make mould rack move down to end point and close. Make blow pin fall slowly and stop when blowing mouth approaches mould bottle mouth. For safe, before this operation, adjust the adjusting cover of blow pin oil cylinder to position where blow pin will not touch mould, even if it falls completely. Watch whether blowing mouth centralizes with bottle mouth or not.
| Parameters | MP90FS |
| Material | PE PP PVC PA… |
| Max container capacity | 10L |
| Number of die | 1,2,3,4,6,8 |
| Machine Dimension(LxWxH) | 5x5.9x3.1m |
| Total weight | 12ton |
| Clamping force | 350kN |
| Platen openning stokes | 240-560mm |
| Toggle stokes | 1150mm |
| Max mould size(WxH) | 1100x430mm |
| Screw diameter | 90mm |
| Screw L/D ratio | 24 L/D |
| (HDPE) Plasticizing capacity | 150kg/h |
| Screw heating zone | 4 zone |
| Screw heating power | 16.5kw |
| Screw fan power | 0.14kw |
| Extrusion motor power | 45kw |
| Die head heating zone | 16 zone |
| Power of die heating | 21kw |
| Total power of machine | 160kw |
| Power of oil pump motor | 31kw |
| Air pressure | 0.6-0.8 Mpa |
| Average energy consumption | 80kw |
| Consumption compression air | 1.5m³/min |
| Consumption cooling water | 150L/min |
Contact Person: Levi.Li
Tel: 86-13396686968
Fax: 86-574-81688011
