The brands of domestic blow molding machines are emerging one after another. According to preliminary statistics, there are currently nearly one hundred manufacturers of blow molding machines in China. The operating interfaces of blow molding machines manufactured by different manufacturers have different levels of differences. To facilitate the deep understanding of blow molding machines by industry personnel, Here is a brief introduction to the operation of the blowing molding machine:
1. Without professional training personnel, can not operate the blowing molding machine.
2. Ensure that the machine ground zero before the boot, to avoid leakage of electricity caused by unsafe accidents.
3. Blow molding machine before heating, should examine each part of the cooling water carefully whether connected.
4. The fully automatic blow molding machine before the operation, will rise to a suitable position, to ensure that the head and the template do not collide, to avoid damage to the equipment.
5. The pressure of the machine system has been set before the factory, no special circumstances can be arbitrarily adjusted to avoid the pressure too high or too low to cause damage to the hydraulic system or affect the normal operation of the machine.
6. Workers are strictly prohibited on the machine to add materials to avoid electric shock or scald and fall at high altitude.
7. The blow molding machine in the mode switch action, operators are prohibited from entering the safety door area to avoid being sandwiched or hit.
8. Fully automatic blow molding machine in the normal operation of production, do not use your hands to break the material that is extruding, to avoid high temperature material and electric heat cutting knife burns or mold clamping.
9. When adjusting the motion-shifting, motion-closing photoelectric switch, must turn off the main oil pump, avoid the occurrence of unsafe accidents.
10. In case of emergency, quickly press the red emergency stop button to prevent accidents.
Contact Person: Mr. Levi.Li